RBC Lysis Buffer, 10X

사용법 :

RBC lysis buffer is supplied as a 10X solution and should be diluted to 1X in deionized water. 100 ml of 10X concentrate will yield a quantity of 1X solution that is sufficient to lyse 500 samples.



The pH of the 1X solution should fall within the range of pH 7.1-7.4. Adjust the pH if necessary. Warm the 1X solution to room temperature prior to use.



NOTE: The blood sample must be <1 month old and been stored in anticoagulants (i.e. EDTA, heparin, and citrate).



PROTOCOL

1. Add whole blood to RBC Lysis Buffer at a ratio of approximately 1 part blood to 2 parts Lysis Buffer. Invert the tube to mix and incubate for 5 minutes at room temperature on a shaking platform or with periodic inversions. Do not vortex.

2. Centrifuge for 5 minutes then remove supernatant carefully without disturbing the pellet.


Note: If pellet is not white, repeat steps 1 and 2 with additional RBC Lysis Buffer.

3. If a lower red pellet is still visible below the white pellet then repeat steps 1 and 2 with fresh blood with the following modifications: a. Ensure the RBC Lysis Buffer is at room temperature. b. Increase the incubation to 15 minutes c. Use a higher ratio of RBC Lysis Buffer to blood (3:1).

공식화 :

10X

건강 상태 :

Liquid

용해도 :

Soluble in water.

pH :

7.1-7.4

저장 :

Store at 4° C