ROS Probe, HPF (CAS 359010-69-8)

Utilisation :

To prepare soultion, dilute 500-5,000-fold (~10-1µM) in phosphate buffer (0.1M phosphate, pH 7.4) immediately before use. BSA, phenol red and amines may affect the fluorescence and must be used with caution. Do not store the dilutions.
Precautions for use
1. Prepare the diluted solution just before use and use it up.
2. The dilution buffer should be adjusted to pH 7.0-7.5. Please note that bovine serum albumin (BSA) and phenol red might interfere with the fluorescence measurement.

Light-induced autoxidation (Figure 3)
After adding HPF or DCFH-DA (10µM), the cells were incubated for 30 min at 37°C in the dark. The fluorescence images were obtained with a confocal fluorescent microscope (excitation wavelength: 488nm, fluorescence emission wavelength: using a 515nm barrier filter). The cells were laser-irradiated again at 488nm for 10 sec and fluorescence images were obtained again (see Figure 3).

Fluorescence images of HPF- or APF-loaded neutrophils (Figure 4)
Neutrophils were obtained from porcine blood and suspended in Krebs-Ringer phosphate buffer (114mM NaCI, 4.6mM KCI, 2.4mM MgSO4, 1.0mM CaCI2, 15mM NaH2PO4/Na2HPO4, pH 7.4) and kept on ice until use. Then they were seeded onto a glass-bottomed dish. The cells were loaded with HPF or APF (10µM) by incubation for 30min at room temperature and then stimulated with PMA (including 2ng/ml; 0.1% DMF as a cosolvent). Fluorescence images were obtained with a confocal fluorescent microscope before and 10 min after the stimulation with PMA (excitation wavelength: 488nm, fluorescence emission wavelength: 505-550nm; using a 505-550nm barrier filter).

Detection of hROS in the HRP/H2O2 system using HPF and APF (Figure 5)
Reaction timecourse
Fluorescence probe reagents (final 10µM; 0.1% DMF as a cosolvent) were added to sodium phosphate buffer (0.1M; pH 7.4) containing HRP (0.2µM). H2O2 (final 1µM) was added at the time indicated by the arrow. The fluorescence intensities were measured at excitation wavelength of 490nm and fluorescence emission wavelength of 515nm. Relation between the amount of added H2O2 and fluorescence increase in the HRP/H2O2 system.

Relation between the amount of added H2O2 and fluorescence increase in the HRP/H2O2 system
Fluorescence probe reagents (final 10µM; 0.1% DMF as a cosolvent) were added to sodium phosphate buffer (0.1M; pH 7.4) containing HRP (0.2µM). The fluorescence intensities were measured at excitation wavelength of 490nm and fluorescence emission wavelength of 515nm.

Formulation :

~5mM in 0.47 ml dimethylformamide

État Physique :

Liquid

Stockage :

Store at -20° C

Point d'Ébullition :

153° C

Fluorescence :

λex ~490 nm, λem ~515 nm

PubChem CID :

SMILES :

C1=CC=C2C(=C1)C(=O)OC23C4=C(C=C(C=C4)O)OC5=C3C=CC(=C5)OC6=CC=C(C=C6)O